Inflatable Restraint Steering Wheel Module Replacement

Fig 1: Identifying Inflatable Restraint Steering Wheel Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Cautions and Notices. CAUTION: Refer to SIR Caution in Cautions and Notices. NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Tools Required: J 44298 Driver Air Bag Removal Tool. See Special Tools .
Preliminary Procedures Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling Zone 3 . On the back side of the steering wheel are 4 openings, place the wheel so that 2 openings are on top. Install the J 44298 , and push the handle back towards the I/P releasing the spring loaded fasteners at the same time. See Special Tools . Repeat the steps for the other 2 openings.
1	Lead, Horn Ground Tip: Tilt the steering wheel module towards the rear of the vehicle to access the lead and connectors.
2	Connector, Steering Wheel Inflatable Restraint Module Electrical (Qty: 2)
3	Module, Steering Wheel Inflatable Restraint Tip: Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .