LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Fuel Tank Module Replacement - Primary >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. If the fuel level sending unit is being replaced, install the fuel level sending unit onto the new fuel pump. Refer to Fuel Level Sensor Replacement - Primary .
    Fig 1: View Of Fuel Tank Module
    GM1226439Courtesy of GENERAL MOTORS CORP.
  2. Insert the new primary fuel pump module assembly with the level sender and the new fuel pump-to-tank seal. Ensure the orientation tabs are aligned.
  3. Use the J 45722  to install the fuel pump lock ring. See Special Tools .
  4. Connect the wiring harness to the primary fuel pump module and fuel tank pressure sensor.
  5. Install the secondary fuel pump module. Refer to Fuel Tank Module Replacement - Secondary .
  6. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals