Installation Procedure

Fig 1: View Of EBCM & BPMV

Courtesy of GENERAL MOTORS CORP.

Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
Install the EBCM (1) to the BPMV (2). Use care when aligning the EBCM (1) to the BPMV electrical terminals (3).

Fig 2: View Of EBCM-To-BPMV Retaining Bolts
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the 4 EBCM-to-BPMV retaining bolts (1). Tighten the bolts in a criss-cross pattern.
Tighten: Tighten the bolts to 3 N.m (27 lb in).

Fig 3: View Of EBCM Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector to the EBCM.
Turn the ignition switch to the ON position. DO NOT start engine.
Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.