Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line, 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.

Connect the stop lamp switch electrical connector.
Insert the stop lamp switch into the retainer.

Fig 1: View Of Stop Lamp Switch

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the accelerator pedal to the dash panel. Install the retaining nuts.
Tighten: Tighten the accelerator pedal retaining nuts to 10 N.m (89 lb in).

Fig 2: View Of Accelerator Pedal

Courtesy of GENERAL MOTORS CORP.

Adjust the stop lamp switch. Refer to Stop Lamp Switch Adjustment .