LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 861 (Suspension Control System - Automatic Level Control) >> Repair Instructions >> Air Compressor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Compressor & Bolts
    GM344303Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the heat shield on the air compressor bracket with 3 bolts.

    Do not install the fourth heat shield bolt. It must be installed after the air tube is connected.

    Tighten:  Tighten the bolts to 4 N.m (35 lb in).

  2. Install the air compressor connector to the connector anchor.
    3. Fig 2: Identifying Air Compressor Assembly
    GM344295Courtesy of GENERAL MOTORS CORP.
  3. Install the air compressor assembly on the vehicle with 2 nuts and 2 bolts.

    Tighten: 

    • Tighten the bolts to 9 N.m (80 lb in).
    • Tighten the 2 nuts to 9 N.m (80 lb in).

  4. Connect the harness connector to the air compressor connector.
  5. Install the intake air filter on the vehicle.
    6. Fig 3: View Of Air Compressor & Bolts
    GM344303Courtesy of GENERAL MOTORS CORP.
  6. Connect the air tube to the air dryer.
  7. Connect the air tube and the harness tie to the air compressor bracket with the bolt.

    Tighten:  Tighten the bolt to 4 N.m (35 lb in).

    8. IMPORTANT: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will ensure that the air adjustable shock absorbers are filled with residual pressure.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals