Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line, 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.

Install the inflator bracket tabs in the slots in the upper lock pillar sheet metal.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the inflator fastener.
Tighten: Tighten the fasteners to 10 N.m (89 lb in).

IMPORTANT: Pull up on each snap-in fastener without depressing the locking tab to verify that the fastener is installed correctly.

Install the rear tether snap-in fastener. Ensure that the fastener locks in place.

Fig 1: View Of Roof Rail Module

Courtesy of GENERAL MOTORS CORP.

Install the remaining snap-in fasteners.
Install the tether channel push-in fastener.

Fig 2: View Of Tether Channel Push-In Fasteners

Courtesy of GENERAL MOTORS CORP.

Install the front tether snap-in fastener. Ensure that the fastener locks in place.

Fig 3: View Of Tether Snap-In Fastener

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector on the inflator.
Install the electrical connector CPA.
Install the headliner. Refer to Headliner Replacement (w/ Sunroof) or Headliner Replacement (w/o Sunroof) in Interior Trim.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 (Coupe) or SIR Disabling and Enabling Zone 2 (Sedan) or to SIR Disabling and Enabling Zone 6 (Coupe) or SIR Disabling and Enabling Zone 6 (Sedan) .