LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Controls (Introduction)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press the IAT sensor (3) into the engine.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the IAT sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Connect the IAT sensor harness connector.
    4. Fig 1: Locating ECT Sensor, Boost Control Solenoid, & IAT Sensor
    GM1389396Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals