Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: The KS threaded surfaces must be clean before installation.

Install the knock sensor.
Tighten: Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).
Connect the knock sensor harness connector.

Fig 1: View of Knock Sensor

Courtesy of GENERAL MOTORS CORP.

Install the starter. Refer to Starter Motor Replacement (2.2L (L61)) or Starter Motor Replacement (2.0L (LSJ)) in Engine Electrical.