Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Electronic Brake Control Module (EBCM) & Brake Pressure Modulator Valve (BPMV)

Courtesy of GENERAL MOTORS CORP.

Turn the ignition switch to the OFF position.
If equipped with RPO LSJ, remove the throttle body air snorkel.
Clean the electronic brake control module (EBCM) (3) to brake pressure modulator valve (BPMV) (4) area of any accumulated dirt and foreign material.
Remove the 4 EBCM-to-BPMV retaining bolts (2).
Disconnect the electrical connector (1) from the EBCM (3).

IMPORTANT: Do Not use a metal tool to pry the EBCM from the BPMV. Use care to ensure that the EBCM-to-BPMV mating surfaces are not scratched during EBCM removal.

Separate the EBCM (3) from the BPMV (4) by carefully pulling apart.