LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Engine Controls - Introduction) >> Repair Instructions >> Ignition Coil Housing Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ignition coil housing to the camshaft cover.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition coil housing retaining bolts.

    Tighten:  Tighten the retaining bolts to 10 N.m (89 lb in).

    3. Fig 1: View Of Ignition Coil & Module Assembly
    GM412144Courtesy of GENERAL MOTORS CORP.
  3. Install the ICM. Refer to Ignition Control Module Replacement .
  4. Install the accelerator and cruise control cables bracket.
  5. Install the accelerator and cruise control cables bracket bolts.

    Tighten:  Tighten the retaining bolts to 10 N.m (89 lb in).

  6. Install the accelerator and cruise control cables to the bracket.
scientia non olet · About LEMON Manuals