Alarm Module: Service and Repair

Theft Deterrent Module Replacement

Removal Procedure

1. Disable the SIR. Refer to SIR Disabling and Enabling.
2. Remove the trim covers.
3. Remove the theft deterrent module wiring harness from the steering column harness.
4. Disconnect the electrical connector.




5. Pull the theft deterrent module (2) away from the lock cylinder housing (1).

Installation Procedure




1. Push the theft deterrent module (2), onto the lock cylinder housing (1).
2. Install the theft deterrent wiring harness to the steering column harness.
3. Connect the electrical connector.
4. Replace the steering column trim covers.
5. Enable the SIR system. Refer to SIR Disabling and Enabling.
6. Program the new theft control module. For programming and setup information. Refer to Programming and Relearning Programming and Relearning