LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Relay 3.9 1 >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System >> Repair Instructions >> Object Alarm Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Electrical Connector & Rear Object Detection Module
    GM733623Courtesy of GENERAL MOTORS CORP.
  1. Align the rear object detection module to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the rear object detection module mounting bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Install the electrical connector to the rear object detection module and press in the locking tab.
  4. Install the rear compartment side trim. Refer to Rear Quarter Trim Panel Replacement - Right Side .
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals