BCM Inputs

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.

Ambient Light Sensor C67-HVAC Manually equipped vehicles only: The Ambient Light sensor inputs the light level status to the BCM. The daylight light levels are Day/Night/Unknown/Invalid.
Ambient Light Sensor C67-HVAC Manually equipped vehicles only: The Ambient Light Sensor defines the light level to a voltage between 0 to 5 volts.
Flash to Pass: The scan tool displays Active/Inactive. When the multifunction switch is placed on the FTP position, the scan tool will display Active.
Front Fog Lamp Switch: The scan tool displays Active/Inactive. When the fog lamp switch is placed in the ON position, the scan tool will display Active.
Hazard Lamp Switch: The scan tool displays Active/Inactive. When the hazard switch is placed in the ON position, the scan tool will display ON.
Headlamp Switch: The scan tool displays Active/Inactive. When the headlamp switch is placed in the ON position, the scan tool will display ON.
Headlamp OFF Switch: The scan tool displays ON/OFF. When the headlamp switch is placed in the OFF position, the scan tool will display ON.
High Beam Select Switch: The scan tool displays ON/OFF. When the headlamp dimmer switch is placed in the HIGH position, the scan tool will display ON.
Left Turn Signal Switch: The scan tool displays Inactive/Active. When the turn signal switch is placed in the LEFT turn position, the scan tool will display Active.
Left Front Turn Signal: The scan tool displays ON/OFF. When the left front turn signal is placed in the ON position, the scan tool will display ON.
Left Rear Turn Signal: The scan tool displays ON/OFF. When the left rear turn signal is placed in the ON position, the scan tool will display ON.
Low Beam Relay Command: The scan tool displays ON/OFF. When the headlamp dimmer switch is placed in the LOW position, the scan tool will display ON.
Park Lamp Relay Command: The scan tool displays ON/OFF. When the headlamp switch is in the PARK position, the scan tool will display ON.
Park Lamp Switch: The scan tool displays ON/OFF. When the headlamp switch is in the PARK position, the scan tool will display ON.
Right Turn Signal Switch: The scan tool displays Inactive/Active. When the turn signal switch is placed in the right turn position, the scan tool will display Active.