LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Sky Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls & Fuel - 2.4L - DTC P0010 To P0354 >> DTC P0106 >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

    IMPORTANT: You must perform the circuit/system testing, in order to verify the integrity of the MAP sensor circuits, before proceeding with the component testing.
  1. Ignition ON, remove the MAP sensor.
  2. Install a 3A fused jumper wire between the 5-volt reference circuit terminal C and the corresponding terminal of the MAP sensor.
  3. Install a jumper wire between the low reference circuit terminal A of the MAP sensor and ground.
  4. Install a jumper wire at terminal B of the MAP sensor.
  5. Connect a DMM between the jumper wire from terminal B of the MAP sensor and ground.
  6. Install the J 35555  to the MAP sensor vacuum port. Slowly apply vacuum to the sensor while observing the voltage on the DMM. The voltage should vary between 0-5.2 volts, without any spikes or dropouts.
    • If the voltage is not within the specified range or is erratic, replace the MAP sensor.
scientia non olet · About LEMON Manuals