LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Sky Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Supplemental Inflatable Restraint System) >> Specifications >> Fastener Tightening Specifications
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications

Application Specification
Metric English
Driver Information Center Display Switch Screw 2 N.m 18 lb in
Electronic Control Unit Screw 2 N.m 18 lb in
Front End Inflatable Restraint Discriminating Sensor Bolt 9 N.m 80 lb in
Inflatable Restraint Sensing and Diagnostic Module (SDM) Bolt 10 N.m 89 lb in
Inflatable Restraint Side Impact Module Nut 5 N.m 44 lb in
Inflatable Restraint Side Impact Sensor Bolt 10 N.m 89 lb in
Inflatable Restraint Steering Wheel Module Coil 2.5 N.m 22 lb in
Instrument Panel Compartment Screw 2 N.m 18 lb in
Instrument Panel Inflatable Restraint Module 10 N.m 89 lb in
Seat Belt Guide Loop Nut 42 N.m 31 lb ft
Seat Belt Retractor Bolt 42 N.m 31 lb ft
Steering Column Lower Shroud Bolt 1.5 N.m 13 lb in
Steering Column Upper Shroud Bolt 3.5 N.m 31 lb in
Steering Wheel Nut* 40 N.m 30 lb ft
* This is a prevailing torque type fastener. This fastener may be reused ONLY if:
  • The fastener and its counterpart are clean and free from rust.
  • The fastener develops a specified amount of torque (drag) against its counterpart prior to the fastener seating.

If the fastener does not meet these criteria, REPLACE the fastener.
scientia non olet · About LEMON Manuals