Circuit/System Verification
- Ignition ON, observe the scan tool APP sensor 1 voltage parameter. The reading should be between 0.84-4.82 volts and change with accelerator pedal input.
- Ignition ON, observe the scan tool APP sensor 2 voltage parameter. The reading should be between 0.66-4.82 volts and change with accelerator pedal input.
- Ignition ON, observe the scan tool APP Sensor 1 and 2 parameter. The scan tool should indicate agree.
- Clear the DTCs with the scan tool. Operate the vehicle within the Conditions for Running the DTC, or within the conditions that you observed from the Freeze Frame/Failure Records.
- Verify that DTCs P0641 or P0651 are set.
- If DTCs P0641, P0642, P0643, P0651, P0652, P0653, P0697, P0698 or P0699 is set, refer to DTC P0641, P0642, P0643, P0651, P0652, P0653, P0697, P0698 or P0699 .