Intake Air Temperature Sensor 2 Replacement

Intake Air Temperature Sensor 2 Replacement

Removal Procedure




1. Turn the ignition OFF.
2. Disconnect the intake air temperature (IAT) sensor harness connector.
3. Remove the IAT sensor from the side of the intake manifold (5).

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the IAT sensor to the side of the intake manifold (5).

Tighten the IAT sensor to 18 N.m (13 lb ft).

2. Connect the IAT sensor harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.