Input Speed Sensor Replacement

Input Speed Sensor Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.




2. Disconnect the wiring harness from the input speed sensor.

Important: Do not damage the input speed sensor or transaxle case.

3. Remove the input speed sensor bolt/screw.
4. Remove the input speed sensor, and the input speed sensor O-ring.

Installation Procedure




1. Apply automatic transmission fluid to the new input speed sensor O-ring seal.
2. Install the new input speed sensor O-ring seal onto the input speed sensor.
3. Install the input speed sensor into the transmission case assembly.

Notice: Refer to Fastener Notice.

4. Install the input speed sensor bolt.

Tighten the bolt to 12 N.m (106 lb in).

5. Connect the wiring harness to the input speed sensor.
6. Lower the vehicle.