Circuit/System Testing
WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to SIR Caution
.
- Ignition OFF, disconnect the harness connector at the audio steering wheel control switch.
- Ignition ON, test for 10-12 volts between the voltage circuit and ground at the switch harness connector.
- If less than 10 volts, test the voltage circuit for a short to ground or an open/high resistance. If circuit test normal, replace the BCM.
- Test for 0-0.5 volts between the signal circuit and ground at the switch harness connector.
- If greater than 0.5 volts, test the signal circuit for short to voltage. If circuit test normal, replace BCM.
- Test for 10-12 volts between the voltage circuit and the signal circuit at the switch harness connector.
- If less than 10 volts, test the signal circuit for an open/high resistance. If circuit test normal, replace the BCM.
- Ignition OFF, disconnect the harness connector at the BCM.
- Test for infinite resistance between the signal circuit and ground at the harness connector.
- If less than infinite resistance, test the signal circuit for a short to ground. If circuit test normal, replace the BCM.
- If all circuits test normal, test or replace switch.