Circuit/System Testing
- Disconnect the EVAP vent pipe from the EVAP canister vent solenoid valve.
- Seal the EVAP vent pipe using a plug from the J 41413-300 .
- Turn ON the ignition.
- Command the EVAP canister purge solenoid valve to 0 percent with a scan tool.
- Start the engine.
- Observe the FTP sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 volts after 90 seconds.
- If the Fuel Tank Pressure Sensor parameter is greater than the specified range, replace the EVAP canister purge solenoid valve.