Circuit/System Verification
- Place the remote-key on the test pad of the J 43241
and press each button of the remote-key one at a time. See Special Tools . The tester should sound a tone and illuminate a green light when each button is pressed.
- If one or more buttons does not sound the tone and illuminate the green light, replace the remote-key battery and retest with the J 43241
. See Special Tools . If the condition continues after battery replacement, replace the remote-key.
- Verify the scan tool Transponder Key parameter for the appropriate remote-key is Programmed.
- If not the specified value, program the remote-key. Refer to Replacing Keys
.
- Operate the remote-key while observing the scan tool Remote Key Function parameters. The parameter should correspond with the function selected on the remote-key.
- If the parameter does not match the function selected on the remote-key, program the remote-key and retest. Refer to Replacing Keys
. If the condition continues after remote-key programming, replace the remote-key.
- If all circuits test normal, replace the CIM.