Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Position the sunroof module assembly to the roof opening.
- Hand start the sunroof module assembly bolts (1) into the roof.
- Insert the J 44363 into the sunroof module alignment holes (2).
- Secure the sunroof module assembly to the roof.
Tighten: Tighten the sunroof module bolts (1) to 9 N.m (80 lb in).
- Remove the J 44363 .
- Connect the drain hoses to the drain spouts on the sunroof module.
- Secure the drain hoses to the sunroof module with new tie wraps.
- Connect the electrical harness to the sunroof module assembly.
- Install the sunshade. Refer to Sunroof Sunshade Replacement .
- Install the sunroof window and loosely install the screws. Refer to Sunroof Window Replacement .
- Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment .
- Raise and install the headliner. Refer to Headlining Trim Panel Replacement .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
When installing the new drain hose tie wraps, position the tie wraps to maintain clearance between the tie wraps and the headliner.
IMPORTANT:
Test for proper operation of the sunroof before installing the headliner.