LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2008 >> Sky Red Line, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L - DTC P0010 To DTC P0299 >> DTC P0106 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Verify the integrity of the entire air induction system including all turbocharger components by inspecting for the following conditions:
    • Any damaged components
    • Loose or improper installation including the flexible ductwork of the turbocharger and the CAC
    • An air flow restriction
    • Any vacuum leak
    • In cold climates, inspect for any snow or ice buildup at the BARO port on the ECM
    • A restriction in the MAP sensor port
  2. Ignition OFF, disconnect the harness connector at the MAP sensor.
  3. Ignition OFF for 90 seconds, test for less than 5 ohms between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  4. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 1 and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Verify the scan tool MAP Sensor parameter is less than 1 kPa.
    • If greater than the specified range, test the signal circuit terminal 3 for a short to voltage. If the circuit tests normal, replace the ECM.
  6. Install a 3A fused jumper wire between the signal circuit terminal 3 and the 5-volt reference circuit terminal 1. Verify the scan tool MAP Sensor parameter is greater than 254 kPa.
    • If less than the specified range, test the signal circuit terminal 3 for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  7. If the circuits test normal, test or replace the MAP sensor.
scientia non olet · About LEMON Manuals