LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2009 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Suspension Control System - Automatic Level Control (ALCM)) >> Repair Instructions >> Automatic Level Control Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Height Sensor, Connector, Ball Stud, Tab & Nut
    GM517954Courtesy of GENERAL MOTORS CORP.
  1. Insert head of the sensor mounting stud into the key hole.
  2. Slide the sensor upward until the anti-rotation tab engages in the lower hole.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the sensor mounting nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  4. Connect the sensor link on the ball stud.
  5. Connect the height sensor connector.
  6. Install the wheel on the vehicle. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
  8. Refer to Control Module References for replacement and setup information.
scientia non olet · About LEMON Manuals