Specifications Index
SKY & SOLSTICE SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT SYSTEM CAPACITIES | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel Drive Shaft Nut | |||
| Rear | 159 lb ft (215 N.m) | ||
| Battery | BATTERY USAGE | ||
| Brakes | |||
| Bleeding Sequence | RR, LF, LR, RF | ||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drum Brakes | NA | ||
| Charging | |||
| Generator | GENERATOR USAGE | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | NA | ||
| Belt Routing | |||
| 2.0L | See appropriate figure under DRIVE BELT REPLACEMENT | ||
| 2.4L | See appropriate figure under DRIVE BELT REPLACEMENT (WITH A/C) or DRIVE BELT REPLACEMENT (WITHOUT A/C) | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM DESCRIPTION AND OPERATION | ||
| Radiator Cap Pressure | Radiator cap pressure is stamped on cap. | ||
| Thermostat R & I | |||
| 2.0L | ENGINE COOLANT THERMOSTAT REPLACEMENT (LNF) | ||
| 2.4L | ENGINE COOLANT THERMOSTAT HOUSING REPLACEMENT (LE5) | ||
| Water Pump R & I | |||
| 2.0L | WATER PUMP REPLACEMENT (LNF) | ||
| 2.4L | WATER PUMP REPLACEMENT (LE5) | ||
| Engine Mechanical | |||
| 2.0L | |||
| Compression | ENGINE COMPRESSION TEST | ||
| Oil Pressure | 50-80 psi (344.75-551.60 kPa) Minimum at 1,000 RPM | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| 2.4L | |||
| Compression | ENGINE COMPRESSION TEST | ||
| Oil pressure | 50-80 psi (344.75-551.60 kPa) Minimum at 1,000 RPM | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive PlateTorque | |||
| First Pass | 39 lb ft (53 N.m) | ||
| Final Pass | 25 degrees | ||
| Fuel System | |||
| 2.0L | |||
| Pressure Specification | 57-67 psi (395-464 kPa) | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM DIAGNOSIS (EXCEPT SATURN) or FUEL SYSTEM DIAGNOSIS (SATURN ONLY) | ||
| Fuel Filter Location | Fuel strainer attaches to the lower end of the fuel pump module. | ||
| Fuel Filter R & I | Fuel strainer normally requires no maintenance. | ||
| 2.4L | |||
| Pressure Specification | 57-67 psi (395-464 kPa) | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM DIAGNOSIS (EXCEPT SATURN) or FUEL SYSTEM DIAGNOSIS (SATURN ONLY) | ||
| Fuel Filter Location | Fuel strainer attaches to the lower end of the fuel pump module. | ||
| Fuel Filter R & I | Fuel strainer normally requires no maintenance. | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil on Plug | ||
| Ignition Wires (Routing) | Coil on Plug | ||
| Spark Plug | |||
| 2.0L | |||
| Type | NA | ||
| Gap | 0.035-0.030 in (0.9-0.75 mm | ||
| Torque | 12.5-17 lb ft (17-23 N.m) | ||
| 2.4L | |||
| Type | NA | ||
| Gap | 0.043-0.037 in (101-0.95 mm) | ||
| Torque | 15 lb ft (20 N.m) | ||
| Starting | |||
| Starter | STARTING SYSTEM DESCRIPTION AND OPERATION | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 lb ft (140 N.m) | ||