Electronic Brake Control Module: Testing and Inspection

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed.

EBCM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning).

EBCM Programming and Setup - Hybrid

If the electronic brake control module (EBCM) is replaced or needs reprogrammed, the following procedures must be performed:

* EBCM Reprogramming--Refer to Service Programming System (SPS) (Programming and Relearning).
* Perform the module setup EBCM Relearn.
* Perform the module setup Acceleration Sensor Reset.
* Perform the module setup BMC Prim. Piston Pos. Relearn.

Setup for Component Replacement

The replacement of ABS components such as the steering wheel position sensor may require a setup procedure for complete repair. Refer to Steering Angle Sensor Centering (Procedures)