Circuit/System Testing
- Ignition OFF, disconnect the harness connectors at the BCM.
- Ignition OFF and scan tool disconnected, open and close the driver door, and wait 30 seconds. Test for less than 5 Ω between the ground circuit terminals listed below and ground.
- Terminal 1 X3
- Terminal 5 X3
- Terminal 9 X4
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the B+ circuit terminals listed below and ground.
- Terminal 3 X3
- Terminal 10 X4
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the BCM.