LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1175 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C0292 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the yaw rate/lateral accelerometer sensor.
  2. Test for less than 5 ohms of resistance between the low reference circuit terminal 5 and ground.
    • If greater than the specified range, test for an open/high resistance in the low reference circuit. If the circuit tests normal, replace the EBCM.
  3. Ignition ON, test for B+ between the voltage circuit terminal 3 and ground.
    • If less than the specified range, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
  4. Ignition OFF, disconnect the harness connector at the EBCM.
  5. Ignition ON, test for 0 volts between the CAN bus low circuit terminal 1 and ground at the yaw rate/lateral accelerometer sensor connector.
    • If greater than the specified value, test the CAN bus low circuit for a short to voltage.
  6. Test for 0 volts between the CAN bus high circuit terminal 2 and ground.
    • If greater than the specified value, test the CAN bus high circuit for a short to voltage.
  7. If all circuits test normal, replace the yaw rate/lateral accelerometer.
scientia non olet · About LEMON Manuals