LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1632 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Antilock Brake System Automated Bleed >> Automated Bleed Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Automated Bleed Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: The Auto Bleed Procedure may be terminated at any time during the process by pressing the EXIT button. No further Scan Tool prompts pertaining to the Auto Bleed procedure will be given. After exiting the bleed procedure, relieve bleed pressure and disconnect bleed equipment per manufacturers instructions. Failure to properly relieve pressure may result in spilled brake fluid causing damage to components and painted surfaces.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Inspect the brake system for leaks and visual damage. Refer to Symptoms - Hydraulic Brakes . Repair or replace components as needed.
  4. Lower the vehicle.
  5. Prepare the brake bleeding equipment and the vehicle for a pressure bleed of the base hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
  6. Inspect the battery state of charge. Refer to Battery Inspection/Test .
  7. Install a scan tool.
  8. Turn the ignition ON, with the engine OFF.
  9. With the scan tool, perform the following steps:
    1. Select Diagnostics
    2. Select the appropriate vehicle information
    3. Select Chassis
    4. Select Electronic Brake Control Module (EBCM)
    5. Select Special Functions
    6. Select Automated Bleed
  10. With an assistant ready, raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    11. NOTE:
    • Apply the brake pedal when instructed, using moderate effort.
    • Ensure the pedal remains applied until instructed to release by the scan tool.
    • Do not exceed the time period allowed by the scan tool for having the bleeder valves open.
    • The bleed sequence for each corner is as follows:
      • Left front
      • Right front
      • Right rear
      • Left rear
  11. Perform the automated bleed procedure as instructed by the scan tool.
  12. If the automated bleed procedure is aborted, a malfunction exists. If a DTC is detected, refer to Diagnostic Trouble Code (DTC) List - Vehicle to diagnose the DTC.
  13. After completion of the automated bleed procedure, press and hold the brake pedal to inspect for pedal firmness.
  14. If the brake pedal feels spongy, repeat the bleed procedure completely.
  15. Remove the scan tool.
  16. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  17. Lower the vehicle.
  18. Adjust the brake fluid level. Refer to Master Cylinder Reservoir Filling .
  19. Road test the vehicle while confirming the brake pedal remains high and firm.
scientia non olet · About LEMON Manuals