Driving Test

1. Scroll the map screen to display the area to make correction. Press "ENTER" and select "ADJUST CURRENT LOCATION".
2. Correct direction of the vehicle mark.
3. Perform the distance correction of the CONFIRMATION/ADJUSTMENT mode.
   NOTE: Normally, adjustment is not necessary because this system has automatic distance correction function.
4. Are symptoms applicable to "EXAMPLE OF SYMPTOMS JUDGED NOT MALFUNCTION " present after driving the vehicle?

YES or NO 

YES: Limit of the location detection capacity of the navigation system

NO: GO TO 2.

• Does any malfunction occur when the proper test in the following test patterns is performed?
• Test pattern

  Driving test it to find the difference between the symptoms monitored with and without each sensor.

  • Test pattern 1: Test method with no GPS location correction

    Disconnect the GPS antenna connector connected to the NAVI control unit. Accurately adjust the current position and the direction, and then drive the vehicle.

  • Test pattern 2: Test method with no map-matching

    Accurately adjust the current position and the direction. Eject the map DVD-ROM from the NAVI control unit with the ignition switch turned to OFF, and then drive the vehicle. After driving, insert the map DVDROM back in the unit, display the track of the vehicle on the map screen and compare it with the actual road configuration.

• Sample tests
  • < When the current-location mark skips at the same position, to determine, whether it is caused by map matching or by GPS >

    Perform test pattern 1.

  • < To determine if the pattern of streets displayed is correct or not >

    Perform test pattern 1and 2.

    Compare the track of the vehicle on the map screen and the actual road configuration. For fairly accurate tracking, plotting shall be made every several hundred meters.

  • < When the distance is adjusted accurately >

    Perform test pattern 1and 2.

    Drive on a road of which distance is accurately known (by utilizing distance posts on a highway). Calculate the rate of change (increased/decreased) of the distance by comparing with the actual distance.

    Correction = A/B

    A: Distance shown on the screen

    B: Actual distance

YES or NO 

YES :

• If adjustment is insufficient, perform adjustment again.
• If any error is found in the map, please let us know.
• Replace NAVI control unit

NO: Limit of the location detection capacity of the navigation system