Data List/Active Test

DATA LIST

HINT:

Using the hand-held tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

Connect the hand-held tester to the DLC3.
Turn the ignition switch ON.
Read the DATA LIST according to the display on the tester.

DATA LIST (TRANSPONDER KEY ECU ASSY)

Item	Measurement Item/Display (Range)	Normal Condition
KEY SW	Unlock warning switch signal/ON or OFF	ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder
IG SW	Ignition switch signal/ ON or OFF	ON: Ignition switch ON OFF: Ignition switch OFF or ACC
IMMOBILISER	Immobilizer system status/ SET or UNSET	SET: No key is in ignition key cylinder UNSET: Ignition switch ON
RESPONSE	Transponder chip data/ NG or OK	NG: Data error OK: Data OK
FRAME	Transponder chip data/ NG or OK	NG: Data error OK: Data OK
SERIAL NUMBER	Transponder chip data/ NG or OK	NG: Data error OK: Data OK
ENCRYPT CODE	Transponder chip data/ NG or OK	NG: Data error OK: Data OK
STATUS	Transponder chip data/ NG or OK	NG: Data error OK: Data OK
BCC	Transponder chip signal/ NG or OK	NG: Incorrect data sending OK: Correct data sending
SUB KEY	Sub-key code signal/ NOMATCH or MATCH	NOMATCH: Unmatched sub-key code is sent MATCH: Sub-key code is sent
MASTER KEY	Master key code signal/ NOMATCH or MATCH	NOMATCH: Unmatched master key code is sent MATCH: Master key code is sent
REGIST SUB CODE	Number of registered sub-keys/ Min: 0; Max: 3;	Number of registered sub-keys
REGIST MAS CODE	Number of registered master keys/ Min: 0; Max: 5;	Number of registered master keys
REG CODE SPACE	Memory space for key code registration/ NOT FUL or FULL	NOT FUL: Possible to register more key codes FULL: Cannot register any more key codes
ANTENNA COIL	Antenna coil condition/ NORMAL or FAIL	NORMAL: Antenna coil is normal FAIL: Antenna coil is malfunctioning
+B	+B judgment/ NORMAL or BREAK	NORMAL: Battery supply is normal BREAK: Battery supply is malfunctioning
G-CODE SUPPORT	G code judgment/ NOT SUPPORT or SUPPORT	NOT SUPPORT: G code is not supported SUPPORT: G code is supported

ACTIVE TEST

HINT:

Performing the hand-held tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

Connect the hand-held tester to the DLC3.
Turn the ignition switch ON.
Perform the ACTIVE TEST according to the display on the tester.

DATA LIST (TRANSPONDER KEY ECU ASSY)

Item	Normal Condition	Diagnostic Note
SECURITY INDIC	Turn security indicator ON/OFF	-