Transmission Control Cable: Installation

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
1. Install the control cable with the 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 1: Tightening Control Cable With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the clamp to the control cable.
3. Install the clamp to the body with the 2 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 2: Identifying Control Cable Clamp And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the control cable to the control cable bracket, and install 2 new clips.
5. Connect the control cable to the transaxle, and install the 2 washers and 2 clips.
  
  Fig 3: Locating Control Cable Bracket And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
1. Connect the ends of the control cable and install the 2 clips to the shift lever.
2. Turn the lock nuts of the shift cable 270° counterclockwise, and hold them in that position.
3. Install the shift cable while holding them.
4. Check that the cable are installed securely.
  
  Fig 4: Turning Lock Nuts Of Shift Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Push in the cable locks of the shift cable and select cable.
INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
INSTALL EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL CENTER AIRBAG SENSOR ASSEMBLY
INSTALL AIR CONDITIONING UNIT ASSEMBLY (See INSTALLATION )
INSTALL REAR CONSOLE BOX ASSEMBLY (See INSTALLATION )
INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY UPPER (See INSTALLATION )
INSTALL CONSOLE PANEL UPPER (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
1. Perform initialization (see INITIALIZATION ).
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).