Inspection Procedure

1. Disconnect the P15 connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   4 (B) - Body ground	Ignition switch ON	11 to 14 V

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 1: Identifying P15 Power Window Regulator Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE