LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Scion >> 2009 >> xB Automatic >> Repair and Diagnosis >> Engine Performance >> System >> 2AZ-FE Engine Control System - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Accelerator Pedal Rod >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Data List / ACCEL POS #1, ACCEL POS #2
    5. Read the value displayed on the tester.

      ACCEL POS #1 Standard Voltage 

      ACCEL POS #1 STANDARD VOLTAGE

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      ACCEL POS #2 Standard Voltage 

      ACCEL POS #2 STANDARD VOLTAGE

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal assembly, wire harness or ECM.

scientia non olet · About LEMON Manuals