Occupant Classification System: Initialization: Initialization

HINT: 

Perform the zero point calibration and sensitivity check if any of the following conditions apply.

• The occupant classification ECU is replaced.
• Accessories (seatback tray and seat cover, etc.) are installed.
• The front passenger seat is removed from the vehicle.
• The passenger airbag ON/OFF indicator (OFF) comes on when the front passenger seat is not occupied.
• The vehicle is brought to the workshop for repair due to an accident or a collision.

1. ZERO POINT CALIBRATION 
   1. Zero point calibration procedures:

      HINT: 

      Make sure that the zero point calibration has finished normally, and then perform the sensitivity check.

      1. Check that all of the following conditions are met:
         • The vehicle is parked on a level surface.
         • No objects are placed on the front seat RH.
         • The front seat inner belt RH (passenger side buckle switch) is off.
      2. Adjust the seat position in accordance with the table below.

         Adjustment Item	Position
         Slide Direction	Rearmost position
         Reclining Angle	Upright position
         Headrest Height	Lowest position
         Lifter Height	Lowest position

      3. Connect a Techstream to the DLC3.
      4. Turn the ignition switch ON.
      5. Perform the zero point calibration by following the prompts on the tester screen.

         HINT: 

         • Refer to the Techstream operator's manual for further details.
         • If the zero point calibration has not finished normally, replace the front seat RH.
2. SENSITIVITY CHECK 
   1. Sensitivity check procedures:
      1. Connect a Techstream to the DLC3.
      2. Turn the ignition switch ON.
      3. Perform the sensitivity check by following the prompts on the tester screen.

         HINT: 

         Refer to the Techstream operator's manual for further details.

      4. Confirm that the beginning sensor reading is within the standard range.

         Standard range

         -3.2 to 3.2 kg (-7.0 to 7.0 lb)

      5. Place a 30 kg (66.2 lb) weight onto the front passenger seat.
      6. Confirm that the sensitivity is within the standard range.

         Standard range

         27 to 33 kg (59.5 to 72.8 lb)

         HINT: 

         • When performing the sensitivity check, use a solid metal weight (the check result may not be accurate if a liquid weight is used).
         • If the sensitivity deviates from the standard range, retighten the bolts of the front seat RH taking care not to deform the seat rail. After performing this procedure, if the sensitivity is not within the standard range, replace the front seat RH.