DTC P1585: Acceleration Sensor Circuit: Procedure

1. Check for DTCs of the CAN communication system. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

B → See step   5 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List.
5. In accordance with the display on the Techstream, read the Data List.

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   G sensor	Converted output voltage of yaw rate and acceleration sensor/ min.: 0 V max.: 79.998 V	Displays converted voltage of yaw rate and acceleration sensor Vehicle on level ground: 2.31 V to 2.69 V Decelerating: 1.88 V to (2.5) V Accelerating: (2.5) V to 3.11 V G sensor malfunction: set to 1.87 V Communication malfunction: set to 1.87 V	-

   RESULT
   
   

   Result	Proceed to
   Data display is not within Normal Condition range	A
   Data display is within Normal Condition range	B

B → See step   6 

A: Go to next step 

1. Replace yaw rate and acceleration sensor. Refer to REMOVAL .

NEXT: Go to next step 

NEXT → END