LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Scion >> 2013 >> tC Standard Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System (Service Information) >> Steering Angle Sensor >> Removal >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Angle Sensor: Removal: Removal

  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
  3. REMOVE STEERING WHEEL ASSEMBLY 

    Refer to REMOVAL

  4. REMOVE STEERING COLUMN COVER  . Refer to REMOVAL - Step 4
  5. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 

    Refer to REMOVAL - Step 5

    NOTE:
    • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
    • Do not rotate the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
    • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
    • Do not remove the steering angle sensor from the spiral cable with sensor sub-assembly.
scientia non olet · About LEMON Manuals