Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [01/2014 - ]: Procedure

1. Clear the DTC. Refer to DTC CHECK / CLEAR [05/2013 - ] .
2. Check for DTC. Refer to DTC CHECK / CLEAR [05/2013 - ] .

   OK

   DTC B2311 is not output.

NG → See step   9 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / D-Door Motor / Data List.
5. Read the Data List according to the display on the Techstream.
   D-DOOR MOTOR
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver side power window auto switch signal / ON or OFF	ON: Driver side power window auto switch operated OFF: Driver side power window auto switch not operated	-

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

NG → See step   5 

OK: Go to next step 

1. Initialize the power window regulator motor assembly LH. Refer to INITIALIZATION [01/2014 - ] .

NEXT: Go to next step 

1. Check that the driver side power window moves when the auto up and down functions of the power window regulator master switch assembly are operated. Refer to OPERATION CHECK [05/2013 - ] .

   OK

   Driver side power window auto up and down operates normally.

NG → See step   8 

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE) 

1. Remove the power window regulator master switch assembly. Refer to REMOVAL [01/2014 - ] .
2. Inspect the power window regulator master switch assembly. Refer to INSPECTION [05/2013 - ] .

NG → See step   7 

OK: Go to next step 

1. Disconnect the E1 power window regulator master switch assembly connector.
2. Disconnect the E2 power window regulator motor assembly LH connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E1-1 (AUTO) - E2-4 (AUTO)	Always	Below 1 Ω
   E1-1 (AUTO) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   8