Circuit Test: A/T
- Ensure gear select lever is in Park or Neutral position. Turn ignition switch to START position and check for near battery voltage at starter solenoid terminal No. 50 (Black/White wire). If near battery voltage exists and starter does not crank, repair or replace starter. If voltage does not exist, check for voltage at inhibitor switch Black/White wire terminal.
- Inhibitor switch for models equipped with 3AT transmission is located on gear select lever, under console. Inhibitor switch for models equipped with 4AT transmission is located on transmission lever. If near battery voltage exists at inhibitor switch Black/White wire terminal, repair wiring between inhibitor switch and starter.
- If voltage does not exist at inhibitor switch Black/White wire terminal, check for voltage at Black/Yellow wire terminal of transmission inhibitor switch. If voltage does not exist at inhibitor switch Black/Yellow wire terminal, check for voltage to ignition switch BAT terminal and from ignition switch START terminal to inhibitor switch Black/Yellow wire terminal. If voltage does not exist, repair wiring as required or replace ignition switch.