Component Testing: Sub-Switch
Remove power window sub-switch from door panel. Disconnect harness connector. Continuity should exist between specified switch terminals with switch in specified position. See SUB-SWITCH CONTINUITY TEST . SeeFig 1 . If continuity does not exist between specified terminals, replace power window sub-switch.
SUB-SWITCH CONTINUITY TEST
| Switch Position | Terminal No. | Wire Color | |
|---|---|---|---|
| Right Front | |||
| Up | 3 & 4 | RED & BLU | |
| Up | 1 & 2 | BLU/RED & WHT/GRY | |
| Off | 1 & 2 | BLU/RED & WHT/GRY | |
| Off | 4 & 5 | BLU & WHT | |
| Down | 1 & 3 | BLU/RED & RED | |
| Down | 4 & 5 | BLU & WHT | |
| Right & Left Rear | |||
| Up | 3 & 4 | BLK/BLU & BLU/RED | |
| Up | 1 & 2 | BLU & GRY/WHT | |
| Off | 1 & 2 | BLU & GRY/WHT | |
| Off | 4 & 5 | BLU/RED & LT GRN | |
| Down | 1 & 3 | BLU & BLK/BLU | |
| Down | 4 & 5 | BLU/RED & LT GRN | |