Control Assembly: Service and Repair

Control Unit

REMOVAL AND INSTALLATION

1. Disconnect GND cable from battery.
2. Set temperature control switch to "FULL HOT" and mode selector switch to "DEF" position and recirc switch to "FRESH" position.




3. Disconnect temperature control cable and mode door control cable from heater unit then disconnect recirc control cable from intake unit.

NOTE: Do not attempt to move links during installation.

4. Remove console box.
5. Remove center panel and then disconnect connector.




6. Remove audio.




7. Remove control unit assembly from center console.
8. Installation is in the reverse order of removal.

NOTE: Before installing control unit, set temperature control switch to "FULL HOT" and mode selector switch to "DEF" position and recirc switch to "FRESH" position.