LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1999 >> Forester S, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Starters >> On-Vehicle Testing >> Ignition Switch Test >> Start Circuit Test
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Start Circuit Test

  1. Remove lower instrument panel below steering column. Remove air duct. Disconnect ignition switch harness connector.
  2. Using jumper wire, apply 12 volts to ignition switch terminal "B". See Figure. Connect test light to switch terminal "S". Turn ignition switch to START position. If test light does not illuminate, replace ignition switch.
scientia non olet · About LEMON Manuals