Rear Combination Light Assembly: Removal: Wagon

WARNING: This page is about a different car, the 2002 Subaru Outback and 2002 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect ground cable from battery.
Remove two rear quarter trim covers.
Remove two nuts and then remove rear combination light while disconnecting connector.

NOTE: Before removing the nuts, apply a few turns of butyl tape to the tip of the service tool. This prevents the nuts from falling during removal.

Fig 1: Removing Two Nuts & Rear Combination Light While Disconnecting Connector

Courtesy of SUBARU OF AMERICA, INC.