Select Cable: Installation

WARNING: This page is about a different car, the 2004 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the select cable to plate assembly.
1. Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
Install the select cable to range select lever.
Install the plate assembly to transmission.
1. Tightening torque: T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
Fig 1: Identifying Adjusting Nuts
Courtesy of SUBARU OF AMERICA, INC.
Install the washer and snap pin to range select lever.

Fig 2: Identifying Washer
Courtesy of SUBARU OF AMERICA, INC.
Move the select lever to "N" range, then adjust the select cable position.< Ref. to ADJUSTMENT . >
Install the heat shield cover. (If equipped)
Install the front and center exhaust pipe.
Non-turbo model

< Ref. to REMOVAL , Front Exhaust Pipe . >

Turbo model

< Ref. to INSTALLATION , Front Exhaust Pipe . >