Read Current Data
- On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
- On the << System Selection Menu >> display screen, select the {Transmission Control System} and press the [YES] key.
- Press the [YES] key after displayed the information of transmission type.
- On the << Transmission Diagnosis >> display screen, select the {Current Data Display & Save} and press the [YES] key.
- On the << Data Display Menu >> display screen, select the {Data Display} and press the [YES] key.
- Using the scroll key, move the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.
REFERENCE DATA LIST
| Contents | Display | Unit of measure |
|---|---|---|
| Battery voltage | Battery Voltage | V |
| Rear vehicle speed sensor signal | Rear Wheel Speed | km/h or MPH |
| Front vehicle speed sensor signal | Front Wheel Speed | km/h or MPH |
| Engine speed signal | Engine Speed | rpm |
| Automatic transmission fluid temperature signal | ATF Temp. | °C or °F |
| Throttle position signal | Throttle Sensor Voltage | V |
| Gear position | Gear Position | - |
| Line pressure control duty ratio | Line Pressure Duty Ratio | % |
| Lock up clutch control duty ratio | Lock Up Duty Ratio | % |
| Transfer clutch control duty ratio | Transfer Duty Ratio | % |
| Power supply for throttle position sensor | Throttle Sensor Power | V |
| Torque converter turbine speed signal | Turbine Revolution Speed | rpm |
| 2-4 brake timing pressure control duty ratio | Brake Clutch Duty Ratio | % |
| Intake manifold pressure sensor voltage | Mani. Pressure Voltage | V |
| 2 wheel drive switch signal (Without VDC system) | FWD Switch | ON or OFF |
| Stop lamp switch signal | Stop Light Switch | ON or OFF |
| Anti lock brake system signal | ABS Signal | ON or OFF |
| Cruise control system signal | Cruise Control Signal | ON or OFF |
| Parking range signal | "P" Range Signal | ON or OFF |
| Neutral range signal | "N" Range Signal | ON or OFF |
| Reverse range signal | R Range Signal | ON or OFF |
| Drive range signal | D Range Signal | ON or OFF |
| 3rd range signal | 3rd Range Signal | ON or OFF |
| 2nd range signal | 2nd Range Signal | ON or OFF |
| 1st range signal | 1st Range Signal | ON or OFF |
| Shift control solenoid A | Shift Solenoid #1 | ON or OFF |
| Shift control solenoid B | Shift Solenoid #2 | ON or OFF |
| Torque control output signal #1 | Torque Control Signal 1 | ON or OFF |
| Torque control output signal #2 | Torque Control Signal 2 | ON or OFF |
| Torque control cut signal | Torque Control Cut Sig. | ON or OFF |
| 2-4 brake timing control solenoid valve | 2-4 Brake Timing Sol. | ON or OFF |
| Low clutch timing control solenoid valve | Low Clutch Timing Sol. | ON or OFF |
| Automatic transmission diagnosis indicator lamp | Diagnosis Lamp | ON or OFF |
NOTE:
For detailed operation procedure, refer to the Subaru Select Monitor Operation Manual.