Vehicle Speed Sensor: Installation
NOTE:
- Discard vehicle speed sensor and after removal, replace with a new one.
- Ensure sensor mounting hole is clean and free of foreign matter.
- Align tip end of key with key groove on end of speedometer shaft during installation.
- Hand tighten vehicle speed sensor.
- Tighten vehicle speed sensor using suitable tool.
- Tightening torque: 5.9 N.m (0.6 kgf-m, 4.3 ft-lb)
- Connect connector to vehicle speed sensor.
- Install front, center exhaust pipes.
< Ref. to INSTALLATION , Front Exhaust Pipe (H4SO).>
- Lower the vehicle.
- Connect battery ground cable.