Read Current Data
- On the << Main Menu >> display screen, select {Each System Check} and press the << YES >> key.
- On the << System Selection Menu >> display screen, select {Brake Control System} and press << YES >> key.
- Press the << YES >> key after the VDC type is displayed.
- On the << Brake Control Diagnosis >> display screen, select {Current Data Display & Save} and press the << YES >> key.
- On the << Data Display Menu >> display screen, select {Data Display} and press the << YES >> key.
- Using the scroll key, move the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.
SUPPORT DATA DISPLAY
| Display screen | Contents to be monitored. | Unit of measure |
|---|---|---|
| FR wheel speed | Wheel speed detected by the Front Right ABS sensor is displayed. | km/h or MPH |
| FL wheel speed | Wheel speed detected by the Front Left ABS sensor is displayed. | km/h or MPH |
| RR wheel speed | Wheel speed detected by the Rear Right ABS sensor is displayed. | km/h or MPH |
| RL wheel speed | Wheel speed detected by the Rear Left ABS sensor is displayed. | km/h or MPH |
| Steering angle sensor | Steering wheel angle detected by the steering angle sensor is displayed. | deg |
| Yaw rate sensor | Vehicle's angular velocity detected by the yaw rate sensor is displayed. | deg/s |
| Lateral G sensor | Vehicle's lateral acceleration detected by the lateral G sensor is displayed. | V |
| Pressure sensor 1 | Brake fluid pressure detected by the primary pressure sensor is displayed. | V |
| Pressure sensor 2 | Brake fluid pressure detected by the secondary pressure sensor is displayed. | V |
| Longitudinal G sensor | Longitudinal G sensor is not equipped on vehicles after '00 MY. But longitudinal G sensor will remain on monitor and 0 V will be displayed. | V |
| ABS CM power voltage | Voltage supplied to VDCCM is displayed. | V |
| Torque driver requires | Engine torque requested by the driver is displayed. | N.m |
| Current torque | Current engine torque is displayed. | N.m |
| Valve relay signal | Drive condition of the valve relay is displayed. | ON or OFF |
| Motor relay signal | Drive condition of the motor relay is displayed. | ON or OFF |
| VDC OFF lamp | ON operation of the VDC OFF indicator lamp is displayed. | ON or OFF |
| Motor relay monitor | Operating condition of the motor relay is displayed. | High or Low |
| PW signal | Accelerator position signal is displayed. | 1 or 0 |
| AET signal | Engine control start signal is displayed. | OPEN or GND |
| AEB signal | Engine control signal is displayed. | OPEN or GND |
| AEC signal | Engine control signal is displayed. | OPEN or GND |
| EAM signal | Engine control command signal is displayed. | 1 or 0 |
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.