Knock Sensor: Installation

Install knock sensor to cylinder block.
Tightening torque:

24 N.m (2.4 kgf-m, 17.4 ft-lb)

NOTE: The extraction area of the knock sensor cord must be positioned at a 60° angle relative to the engine rear.

Fig 1: Installing Knock Sensor To Cylinder Block
Courtesy of SUBARU OF AMERICA, INC.
Connect knock sensor connector.

Fig 2: Connecting Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install air intake chamber. Refer to INSTALLATION , Air Intake Chamber.
Connect battery ground cable.

Fig 3: Installing Air Intake Chamber
Courtesy of SUBARU OF AMERICA, INC.