LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2004 >> Forester XT, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (Security And Locks) >> Security System >> Inspection >> Check Security Indicator Light Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Security Indicator Light Circuit

WARNING: This page is about a different car, the 2005 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CHECKING SECURITY INDICATOR LIGHT CIRCUIT

Step Check Yes No
1 : CHECK SECURITY INDICATOR LIGHT. 
  1. Disconnect the security control unit harness connector.
  2. Ground the harness connector terminal with a suitable wire.

Connector & terminal 
(B93) No. 9 - chassis ground: 		 Does the security indicator light illuminate? Replace the security control unit. Go to step 2  .
2 : CHECK POWER SUPPLY FOR SECURITY INDICATOR LIGHT. 
  1. Disconnect the connector from the combination meter.
  2. Measure the voltage between the combination meter harness connector terminal and chassis ground.

Connector & terminal 
(i10) No. 8 (+) - chassis ground (-): 		 Is the voltage more than 10 V? Go to step 3.  Check the harness for open circuits and shorts between the combination meter and the fuse.
3 : CHECK SECURITY INDICATOR LIGHT CIRCUIT. 
Measure the resistance between the combination meter harness connector terminal and security control unit harness connector terminal.
Connector & terminal 
(i12) No. 4 - (B93) No. 9: 		 Is the resistance less than 10 ohm? Replace the combination meter printed circuit. Check the harness for open circuits and shorts between the combination meter and security control unit.
scientia non olet · About LEMON Manuals