LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2004 >> Forester XT, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (Security And Locks) >> Transmitter >> Replacement >> Transmitter Registration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmitter Registration

WARNING: This page is about a different car, the 2005 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • A maximum of four transmitters can be registered for each individual vehicle.
  • When replacing or adding the transmitter (key), registration is also necessary.
  • Finish the operation from step  1 through  4 within 45 seconds.
  1. Sit on the driver's seat and close all doors and rear gate.
  2. Open the driver's door.
  3. Close the driver's door.
  4. Turn the ignition switch from ON to LOCK ten times within 15 seconds.
    NOTE: Do not start the engine at this time.
  5. The horn chirps one time to indicate that the system has entered in the programming mode.
  6. Open the driver's door.
  7. Close the driver's door.
  8. Press any button on the transmitter that you wish to program into the system.
  9. Horn will chirp two times to indicate that the transmitter has been programmed.
    NOTE: Repeat steps  6 through  9 for an additional transmitter.
  10. Remove the ignition key from the ignition switch.
  11. The horn will chirp three times to indicate that the system has exited the programming mode.
  12. Check the keyless entry system properly operates by operating each transmitter.
scientia non olet · About LEMON Manuals